KitchenAid KDTM354E Dishwasher Repair
The KDTM354E is sold in black stainless (KDTM354EBS) and stainless (KDTM354ESS), and in either finish the door does the hard work: it opens and closes thousands of times, and the latch and seal are where that shows.
We close the door and test the latch switch, then check the strike plate for wear. A run through a short cycle with the door seal in view shows any seepage. If the load comes out cold and wet we measure the heating element, and clearing the spray arms completes the check. You get the written price before any part is ordered. Because both the latch and seal wear together, we usually test them as a pair so the second problem does not show up a month after the first repair. If the door has dropped slightly on its hinges, we adjust it as part of the visit.
The latch or its switch is marginal. We test them and look at the strike for wear, then replace the worn piece. This is common when the strike plate wears, and a small adjustment often restores a firm click.
No. Hose joints and the inlet valve can leak too. We run the wash and drain phases separately to see where water appears. Tracing where moisture first appears settles the matter, and stops a second leak.
Only the door panel finish. Inside, repairs match the stainless model, so we simply match the panel part to your plate number. Black stainless uses the same inner parts, so no special service is needed.
Book in about a minute, or call the desk. Same-day windows inside the Loop on most days, next-day across the rest of Houston.
