KitchenAid KUDE03FT Dishwasher Service
A KUDE03FT can run for years without trouble and then show a damp strip along the front edge of the cabinet. That is nearly always the door seal, which loses its spring with age. The KUDE03FTSS, with plate codes KUDE03FTSS0 or SS1, is built the same way.
We check the seal first, then test the heating element for continuity, because a clean-but-cold load is the other common call on this model. Spray arm bearings and jets get a spin test, and the inlet valve gets a fill test to make sure it shuts off. We also confirm the dishwasher sits level and snug under the counter so the door closes squarely against the new seal.
Our price is written before work starts, and we cover the repair for 30 days.
The door seal is the most likely, but we also check the door edge, the inlet valve and the tub for splash paths. We replace what is worn and watch a full cycle to be sure.
A heating element without continuity cannot warm the rinse or dry the load. We test it with a meter, and if it is open we replace it and confirm heat during a test cycle.
Clogged spray jets or a tired arm bearing are the usual causes. We clear the jets, replace worn arms if they wobble, and check that pressure reaches the upper level.
Book in about a minute, or call the desk. Same-day windows inside the Loop on most days, next-day across the rest of Houston.
