Booking today · Houston service windows 9–12 · 1–4 · 4–7 Independent KitchenAid specialists · Licensed & insured Mon–Fri 7:00 AM - 8:00 PM · Sat 8:00 AM - 6:00 PM
(713) 903-2606 Schedule Service
Model library · KitchenAid Dishwasher

KUDP01IL

KitchenAid KUDP01IL Dishwasher Service

Schedule Service(713) 903-2606
KitchenAid dishwasher

Most common issues on this model

  1. Valve screen clogged with sediment, causing slow or partial fills
  2. Food packed around the sump, the usual source of tub odor
  3. Stuck float switch
  4. Board connection wear

Water level is the topic on most KUDP01IL calls: too much, too little or none at all. The model also appears as KUDP01ILBS and KUDP01ILWH, and each has the same valve and float layout behind the toe-kick.

We take the lower panel off and test the inlet valve with the meter, then flush its screen. The float is checked for debris, the filter and sump are cleaned, and finally we look at the board and panel if the water side is sound. That sequence keeps us from replacing a board that was never the problem. We test the drain pump on the same visit, because a slow drain can masquerade as a valve problem.

A written price comes first, and the work carries a 30-day warranty.

Key features

  • Dishwasher, model KUDP01IL
  • Variants: KUDP01ILBS, KUDP01ILWH
  • Discontinued model
→Codes

Error codes this model can show

F8E4KitchenAid Dishwasher Code F8E4: water in the base, drain sequence runs F8E5KitchenAid Dishwasher Code F8E5: the fill valve is stuck open F9E1KitchenAid Dishwasher Code F9E1: long drain, check filter and hose F9E2KitchenAid Dishwasher Code F9E2: drain motor error and clogs FAE4 or F10E4KitchenAid Dishwasher Code FAE4 or F10E4: diverter valve error FAE5 or F10E5KitchenAid Dishwasher Code FAE5 or F10E5: diverter leak, water under the dishwasher Front Status LightsKitchenAid Dishwasher Front Status Light Colors: what blue, red and white mean Front Status Lights Not IlluminatedKitchenAid Dishwasher Front Status Light Not Illuminated: no color during the cycle
KUDP01ILKUDP01IL questions
My KUDP01IL does not fill at all. What is tested first?

The inlet valve and its screen, plus the supply stop under the sink. A valve that has failed shut admits no water, and a closed stop looks the same.

Could a clogged filter cause my KUDP01ILWH to stop mid-cycle?

It can, since poor drainage keeps water high and may trigger the float. We clean the filter and sump, check the float, and test a full cycle to confirm the tub drains.

Is the board to blame when my KUDP01IL overfills?

Rarely at first. A stuck valve or a held-up float is more common, so we test both before we look at the board or quote a replacement.

Book a visit

Book repair for your KUDP01IL

Book in about a minute, or call the desk. Same-day windows inside the Loop on most days, next-day across the rest of Houston.

(713) 903-2606
☎ Call the desk ▤ Schedule Service