KitchenAid Induction Cooktop Code F0E4: cycle the power first, service if it stays

What F0E4 means

Another power-cycle code on KitchenAid induction cooktops such as the KICU509XSS is F0E4. The first move is to disconnect the cooktop from power, wait a few seconds and reconnect it. If the problem persists, the cooktop must be serviced and the displayed code reported. Until then, owners may find one or more zones dead. The code tells us the induction control, rather than your cookware, raised the alarm. Nothing on the glass surface causes it, so cleaning has no effect.

Common causes of F0E4

A one-time control error that clears after a reset
A power control board that cannot recover
Supply voltage problems at the circuit
A loose or damaged connection inside the cooktop

✓ One safe check you can try

1. Make sure all zones are off. 2. Turn the breaker off, wait a few seconds, then turn it on. 3. Check whether the display is clear and a zone heats a pan. 4. If F0E4 reappears, stop using the cooktop and book us.

! Why to stop there

Persisting F0E4 points to the electronics rather than the pan.
Checking them means working with high voltage.
We give a written quote before any work, and repairs carry a 30-day warranty.

Opening a panel yourself does not automatically cancel a manufacturer warranty, but it can cause accidental damage, and some manufacturers set their own service conditions. Check your warranty terms, or ask us, before deciding.

→Same appliance

Other Cooktop codes

FC E4KitchenAid Induction Cooktop Code FC E4: the harness between touchpad and induction module FC LFKitchenAid Induction Cooktop Code FC LF: left front zone, its coil or its wiring FC LRKitchenAid Induction Cooktop Code FC LR: a left-side zone that will not heat FC RFKitchenAid Smoothtop Cooktop Code FC RF: right front area, element or wiring FC RRKitchenAid Induction Cooktop Code FC RR: the right rear zone does not respond H - Residual HeatKitchenAid Induction Cooktop H: Residual Heat Indicator Indicator or Display FlashingKitchenAid Induction Cooktop Flashing Display: Keys Held Down Indicator or Hot Light OnKitchenAid Smoothtop Cooktop Hot Light On: Control Still On or Element Hot

F0E4F0E4 questions

Does F0E4 need the same steps as F0E2?

They are treated the same way: reset power and call for service if the code stays. The difference is which internal check raised the alarm, which helps us plan the repair.

Can I keep using the other zones?

We advise against it while a code is active. The control may behave unpredictably, so keep the whole cooktop off until it is checked. The control may then behave unpredictably, so do not rely on the zones that still seem to work.

What will you check for F0E4?

We start with the supply at the cooktop, then the connections and control board. You get the price in writing before any part is ordered or replaced.