KitchenAid Dishwasher Code F8E2: fill valve electrical error

What F8E2 means

On KitchenAid built-in dishwashers with the F#E# control, such as the KDPM604KPS and KDTE204KPS, F8E2 is a fill valve electrical error. The control cannot properly drive the inlet valve that lets water in. You see F8E2 on the display and the dishwasher stops. The published steps are to remove the drip tray, inspect the inlet valve connection for leaks and power cycle.

Common causes of F8E2

The fill valve has an electrical problem.
The inlet valve connection is leaking or damaged.
A wiring or control issue to the valve.

✓ One safe check you can try

1. Turn off the water supply and power at the breaker. 2. Look in the drip tray area under the dishwasher, if your model has one, and dry any water. 3. Check that the supply connection looks snug and dry. 4. Restore water and power. 5. Run a short cycle; if F8E2 returns, call us.

! Why to stop there

A weeping valve connection can ruin a floor.
The valve and wiring require a meter.
Written quote first, 30-day guarantee afterward.

Opening a panel yourself does not automatically cancel a manufacturer warranty, but it can cause accidental damage, and some manufacturers set their own service conditions. Check your warranty terms, or ask us, before deciding.

→Same appliance

Other Dishwasher codes

Sanitized light blinking (legacy)KitchenAid Legacy Dishwasher Sanitized Light Blinking: load is not sanitized Start/Resume light blinking (legacy and current)KitchenAid Dishwasher Start/Resume Light Blinking: cycle paused, press within 4 seconds F7E2KitchenAid Dishwasher Code F7E2: wash motor error F8E1KitchenAid Dishwasher Code F8E1: not detecting water, same as H2O F8E4KitchenAid Dishwasher Code F8E4: water in the base, drain sequence runs F8E5KitchenAid Dishwasher Code F8E5: the fill valve is stuck open F9E1KitchenAid Dishwasher Code F9E1: long drain, check filter and hose F9E2KitchenAid Dishwasher Code F9E2: drain motor error and clogs

F8E2F8E2 questions

What is F8E2?

An electrical error at the fill valve, the part that lets water enter. The dishwasher stops because it cannot control the water coming in. It sits on the inlet side of the tub.

Why check for leaks?

The published advice includes inspecting the inlet valve connection for leaks. Water near the valve can point to a bad seal or fitting. Dryness around the valve is a good sign.

How do you repair F8E2?

We test the valve and wiring, replace only what has failed, and give you the price in writing first. Our repair is covered by a 30-day warranty.