KitchenAid KDTM404E Dishwasher Repair
The KDTM404E comes in black, black stainless and stainless as the KDTM404EBL, KDTM404EBS and KDTM404ESS. A cycle that quits halfway with water standing in the tub is a typical call, and a float that stays up is a common cause.
We lift the float, clean the housing and check it with water in the tub before blaming the board. Then we test the touch panel, which ages in the steam, and run a short cycle to watch the dispenser flap open. Last, we look at the rack wheels and rails. The price is given in writing before any work, and our repair carries a 30-day workmanship warranty. Whichever finish you own, the same checks apply, and we confirm the repair by running a full cycle before we leave.
We check the float switch first. If it sticks up, the control thinks the tub is overfull and halts. Freeing and cleaning it often solves the problem.
Not necessarily. A damp connector or a stuck key can cause that. We test the panel and the board connection before replacing anything. A panel that is dry and clean usually responds again once the connection is reseated.
The latch or its spring may be sticky with residue. We clean and test it, and replace the latch only if it fails. Sticky flaps respond to cleaning, so replacement is only for latches that fail the test.
Book in about a minute, or call the desk. Same-day windows inside the Loop on most days, next-day across the rest of Houston.
