Booking today · Houston service windows 9–12 · 1–4 · 4–7 Independent KitchenAid specialists · Licensed & insured Mon–Fri 7:00 AM - 8:00 PM · Sat 8:00 AM - 6:00 PM
(713) 903-2606 Schedule Service
Model library · KitchenAid Dishwasher

KUDJ01TJ

KitchenAid KUDJ01TJ Dishwasher Service

Schedule Service(713) 903-2606
KitchenAid dishwasher

Most common issues on this model

  1. A pump impeller choked with debris that holds a pool in the bottom
  2. A droning, grinding noise that grows louder over a cycle
  3. A misaligned strike or tired latch that blocks starting
  4. Seal that no longer springs back

The KUDJ01TJ, including the KUDJ01TJWH with plate code KUDJ01TJWH0, is a machine whose pump and motor have had a long working life. Hum at the end of a cycle with water still in the bottom is the sign we hear about most.

We clear the pump first, since a bit of glass or a seed can stop it, and then test the motor for a smooth start. If the wash is accompanied by a whine, we assess the wash motor bearing. The latch switch and door seal are checked before we leave, so a no-start or a damp floor does not follow. We also check the drain hose for kinks while the pump is out, so a repaired pump is not undone by a pinched line.

We give a written price before beginning, and the 30-day workmanship warranty covers our work.

Key features

  • Dishwasher, model KUDJ01TJ
  • Variants: KUDJ01TJWH
  • Plate revision: KUDJ01TJWH0
  • Discontinued model
→Codes

Error codes this model can show

Glowing RedKitchenAid Dishwasher Sani Rinse Glowing Red: end-of-Cycle sanitize indicator H2OKitchenAid Dishwasher Display H2O: water not detected during fill Sanitize Light FlashingKitchenAid Dishwasher Sanitize Light Flashing: sanitization temperature not met Sanitized light blinking (legacy)KitchenAid Legacy Dishwasher Sanitized Light Blinking: load is not sanitized Start/Resume light blinking (legacy and current)KitchenAid Dishwasher Start/Resume Light Blinking: cycle paused, press within 4 seconds F7E2KitchenAid Dishwasher Code F7E2: wash motor error F8E1KitchenAid Dishwasher Code F8E1: not detecting water, same as H2O F8E2KitchenAid Dishwasher Code F8E2: fill valve electrical error
KUDJ01TJKUDJ01TJ questions
My KUDJ01TJ hums and leaves water in the bottom. Is the pump dead?

It may only be blocked. We clear the pump and hose first, test the motor and replace the pump only if it still cannot move water.

Is the whining from my KUDJ01TJWH a bearing?

A rising whine usually points to wash motor bearing wear. We confirm where the sound originates, tell you what replacement involves, and quote it before the motor seizes up on you.

My KUDJ01TJ will not start but has power. What is checked?

We test the door latch switch and the strike. If the control does not receive a closed-door signal, the cycle will not begin, and the latch is far cheaper to replace than a board.

Book a visit

Book repair for your KUDJ01TJ

Book in about a minute, or call the desk. Same-day windows inside the Loop on most days, next-day across the rest of Houston.

(713) 903-2606
☎ Call the desk ▤ Schedule Service