KitchenAid KMMS130R 1.9 Cu. Ft. Microwave Hood Repair
Built as a 1.9 cu. ft. microwave hood combination with auto functions, the KMMS130R is also sold as KMMS130RPS. It sits above the range, so its fan and lamps wear alongside the oven itself.
We begin with the filters and blower, then the lamp sockets, door latch and sensing behind the auto cycles. When heating slows, we time a measured load. Prices are written first, and repairs are covered for 30 days.
We finish by running a measured load and listening to the hood at each speed. The mounting screws get a check too, because an over-the-range unit should sit firmly against the cabinet above it.
Anything we find is explained before it is touched.
Tell us the height of the cabinets above the oven when you call, so we bring suitable tools for the kitchen.
The sensing depends on a clear vent path and a door switch that closes fully. We check both and test the sensor circuit, then quote the part that failed.
The filters may be packed or the wheel may be slipping on its shaft. We inspect both and replace the motor only when the tests say it is needed.
Not usually, but a poor socket contact can overheat over time. We test the socket and replace the holder if it is scorched or loose.
Book in about a minute, or call the desk. Same-day windows inside the Loop on most days, next-day across the rest of Houston.
