KitchenAid Induction Cooktop Code FC E0: supply, wiring or the induction module

What FC E0 means

KitchenAid induction cooktops such as the KCIG550JSS display FC E0 for a possible problem with the electrical supply, the associated wiring or the Induction Module. The module is the electronics that actually drives the coils. With FC E0 on the display, zones may refuse to heat and the cooktop can shut down. Because the supply is on the list, a tripped breaker or loose connection is worth ruling out before any part is blamed.

Common causes of FC E0

A supply problem at the breaker or junction
Wiring to the module that is loose or burned
An induction module that has failed
A connector with poor contact

✓ One safe check you can try

1. Turn all zones off. 2. Check that the cooktop breaker has not tripped. 3. Reset the breaker by switching it off for a minute and on again. 4. Stop using the cooktop and phone us if FC E0 remains. 5. Do not open the junction box or touch the cooktop's wiring.

! Why to stop there

Two of the three suspects carry heavy current.
Only a qualified person should test them.
You see the price in writing before work, and a 30-day warranty follows.

Opening a panel yourself does not automatically cancel a manufacturer warranty, but it can cause accidental damage, and some manufacturers set their own service conditions. Check your warranty terms, or ask us, before deciding.

→Same appliance

Other Cooktop codes

FC RFKitchenAid Smoothtop Cooktop Code FC RF: right front area, element or wiring FC RRKitchenAid Induction Cooktop Code FC RR: the right rear zone does not respond H - Residual HeatKitchenAid Induction Cooktop H: Residual Heat Indicator Indicator or Display FlashingKitchenAid Induction Cooktop Flashing Display: Keys Held Down Indicator or Hot Light OnKitchenAid Smoothtop Cooktop Hot Light On: Control Still On or Element Hot LockKitchenAid Induction Cooktop Message "Lock": Control Lock Is Active Other F CodeKitchenAid Induction Cooktop Other F Code: Touchpad, Power Board or Wiring Performance Boost Flashing - Power Level ChangesKitchenAid Induction Cooktop Performance Boost Flashing: power levels change between zones

FC E0FC E0 questions

What is the Induction Module?

It is the power electronics that create the magnetic field under each zone. If it fails, or its supply is bad, the zone cannot heat even though the touch controls respond.

Is FC E0 a wiring problem in my house?

It can be, since the supply is on the list. We start by checking the feed at the cooktop, then move to the module if the feed is good.

Can I keep cooking on other zones?

We recommend not using the cooktop while the code is showing. A weak supply or module can make every zone unreliable. The supply or module may be failing for every zone, not just one. Using it could make the problem worse, so leave the cooktop off until it has been checked.