KitchenAid Built-In Microwave Code 3d41: probe connection alert

What 3d41 means

Some KitchenAid built-in microwaves and combination units, like the KMBP100ESS and KOCE500ESS, show 3d41 when the meat probe connection needs attention. The advice is to verify the probe is securely inserted in its receptacle, which may be in a different spot depending on the model, then reset power and monitor for one minute. Probe-based programs will not start until it clears.

Common causes of 3d41

Probe plug sitting loose in the receptacle
Debris in the receptacle opening
Probe damaged by heat or a drop
Short-lived control confusion

✓ One safe check you can try

1. Press Cancel. 2. Remove the probe and inspect the tip and cord. 3. Reseat the probe with a firm push. 4. If 3d41 is still on the display, shut off the oven's breaker for sixty seconds and turn it back on. 5. Test with a short timed cycle. A repeat code with the probe out is a reason to call.

! Why to stop there

The part you can fix, the probe seating, takes seconds; the rest needs instruments
A technician can tell receptacle trouble from control trouble without swapping parts blindly
You approve the written price first, and the work carries our 30-day warranty

Opening a panel yourself does not automatically cancel a manufacturer warranty, but it can cause accidental damage, and some manufacturers set their own service conditions. Check your warranty terms, or ask us, before deciding.

→Same appliance

Other Microwave codes

Sabbath, Sab, 5Ab, or 5A6KitchenAid Built-In Microwave Display Sabbath, Sab, 5Ab or 5A6: Sabbath Mode is on SEKitchenAid Over-the-Range Microwave Code SE: Keypad or user interface problem Probe or Insert ProbeKitchenAid Combination Microwave Message "Probe" or "Insert Probe": Seat the meat probe in its jack PUSH or PSHKitchenAid Built-In Microwave Message PUSH or PSH: The oven is waiting for Start Registration ErrorKitchenAid Over-the-Range Microwave Message "Registration Error": Check the home network and try again F6KitchenAid Over-the-Range Microwave Code F6: Relay control board FC E2KitchenAid Over-the-Range Microwave Code FC E2: Weak network signal at the microwave F6 E3KitchenAid Built-In Microwave Code F6 E3: Appliance manager and converter control

3d413d41 questions

Where is the probe receptacle on my oven?

It depends on the model, but it is normally on a side wall inside the cavity near the front. If you cannot find it, send us the full model number and we will point you to it.

Why does 3d41 appear when I am not using the probe?

The control may be reading an open or unstable probe circuit. Dried residue in the receptacle or a damaged connection can cause that, so it is worth a professional test.

Is 3d41 covered by cleaning alone?

Cleaning solves it if residue was the issue, and you will see the code stay away after a power reset. Persistent codes suggest a worn receptacle or a wiring problem.