KitchenAid KUDK03FT Dishwasher Service
The KUDK03FT and its KUDK03FTSS version usually bring us one of two questions: why will it not fill, or why does it stop as if the tub were flooded. Both start with the inlet valve and the float.
We test the valve with a meter and run a fill, and we check the screen for sediment. The float is freed and tested, then the filter and sump are cleaned so any slow drainage is ruled out. Only after that do we suspect the control board and panel. We make sure the supply valve under the sink is fully open before testing, since a half-closed valve looks just like a failed inlet.
Our price is written down first, and the repair carries a 30-day workmanship warranty.
Likely, if the valve has failed shut and admits no water. We also check the supply stop and the inlet screen, so we never replace a good part when a closed valve is the cause.
The float switch can be stuck up and sending a false signal. We free it, clean around it and run a full cycle to confirm the message clears and the tub fills normally.
Sometimes. After years of steam, panels and boards can wear. We check the valve, float and filter first, then test the board with a meter, and we explain what we found.
Book in about a minute, or call the desk. Same-day windows inside the Loop on most days, next-day across the rest of Houston.
