Booking today · Houston service windows 9–12 · 1–4 · 4–7 Independent KitchenAid specialists · Licensed & insured Mon–Fri 7:00 AM - 8:00 PM · Sat 8:00 AM - 6:00 PM
(713) 903-2606 Schedule Service
Model library · KitchenAid Dishwasher

KUDP01DL

KitchenAid KUDP01DL Dishwasher Service

Schedule Service(713) 903-2606
KitchenAid dishwasher

Most common issues on this model

  1. No start with door shut
  2. Hardened door seal showing as a damp floor in front of the unit
  3. A burned-out element that never warms the rinse water
  4. A clogged arm that leaves spotty results on the top rack

When a KUDP01DL goes quiet at the start of a cycle, with the lights on but no water running, the door latch is the first place we look. The model was also sold as KUDP01DLBS and KUDP01DLWH, and the latch is shared by all three.

After the latch, we examine the door seal for flattening and cracks, then test the element with a meter. Spray arms are spun by hand and flushed. A seal that no longer springs back often leaves only a faint damp patch, which is why we check it even when the complaint is something else. We also test the door spring tension, because a door that drops open fast stresses the latch.

A written price comes before the repair, and we cover it for 30 days.

Key features

  • Dishwasher, model KUDP01DL
  • Variants: KUDP01DLBS, KUDP01DLWH
  • Discontinued model
→Codes

Error codes this model can show

Front Status LightsKitchenAid Dishwasher Front Status Light Colors: what blue, red and white mean Front Status Lights Not IlluminatedKitchenAid Dishwasher Front Status Light Not Illuminated: no color during the cycle Glowing RedKitchenAid Dishwasher Sani Rinse Glowing Red: end-of-Cycle sanitize indicator H2OKitchenAid Dishwasher Display H2O: water not detected during fill Sanitize Light FlashingKitchenAid Dishwasher Sanitize Light Flashing: sanitization temperature not met Sanitized light blinking (legacy)KitchenAid Legacy Dishwasher Sanitized Light Blinking: load is not sanitized Start/Resume light blinking (legacy and current)KitchenAid Dishwasher Start/Resume Light Blinking: cycle paused, press within 4 seconds F7E2KitchenAid Dishwasher Code F7E2: wash motor error
KUDP01DLKUDP01DL questions
Why will my KUDP01DL not start when the door is closed?

The latch or its switch may not be telling the control the door is shut. We test the switch, check the strike alignment and replace the worn part.

What does a damp spot near my KUDP01DLWH mean?

It usually means the door seal has hardened or flattened. We inspect it along the full length and replace it if it no longer seals.

The KUDP01DL washes but the dishes are cold. Is that the element?

Very likely. We check element continuity with a meter and replace it if it reads open, then run a full cycle to confirm the tub actually warms.

Book a visit

Book repair for your KUDP01DL

Book in about a minute, or call the desk. Same-day windows inside the Loop on most days, next-day across the rest of Houston.

(713) 903-2606
☎ Call the desk ▤ Schedule Service