KitchenAid KUDS01FL Dishwasher Service
A KUDS01FL, including the BT, SS and WH versions, usually calls for the same short list: the drain hose clip, the heater, the diverter and the pump. Each of them wears slowly and none of them gives much warning.
We watch the drain stage with the lower panel off to see whether the clip seeps, then check the heater for scale. After that comes the diverter, and the pump if any water remains in the sump. We confirm the dishwasher is level before leaving and run one more drain cycle, so you can see a dry floor for yourself. Any part we advise replacing is priced in writing and shown to you first.
You get a written price before we begin, and the 30-day workmanship warranty covers the repair.
Probably worn. We replace the clip or the hose section, then watch a drain cycle with the lower panel off to confirm the joint stays dry under pump pressure.
It coats the heater and the spray jets, which weakens heating, spray force and drying. We descale, inspect the heater surface and report on what we find.
We clear the pump and the hose first, since debris often causes this. Then we test the motor and replace the pump only if it still cannot move water.
Book in about a minute, or call the desk. Same-day windows inside the Loop on most days, next-day across the rest of Houston.
