KitchenAid Induction Cooktop Code F0E8: reset the power, then report the code

What F0E8 means

KitchenAid induction cooktops such as the KICU569XSS display F0E8 with the standard reset instruction: disconnect from power, wait a few seconds and reconnect. If the code remains, the cooktop is to be serviced and the exact code reported. You see F0E8 and may find that the zones will not respond to touches. This is an electronics message rather than a cookware or cleaning one, so wiping the glass or swapping pots has no effect, and the control needs a reset before anything else is tried.

Common causes of F0E8

A transient control condition cleared by cycling power
A control or power board that is failing
An unstable electrical supply
Internal wiring that has loosened with heat cycles

✓ One safe check you can try

1. Turn every zone to off. 2. Turn the cooktop's breaker off for a few seconds and then on. 3. Look at the display and test one zone with a pan. 4. Should F0E8 stay, please stop and ring us. 5. Keep cookware off the zones while you troubleshoot so nothing is left heating.

! Why to stop there

If the reset does not clear it, the cause lives in the sealed electronics.
Working there is not safe without training.
Our quote is in writing before we begin, and we give a 30-day workmanship warranty.

Opening a panel yourself does not automatically cancel a manufacturer warranty, but it can cause accidental damage, and some manufacturers set their own service conditions. Check your warranty terms, or ask us, before deciding.

→Same appliance

Other Cooktop codes

FC E1KitchenAid Induction Cooktop Code FC E1: touchpad or the cable behind it FC E4KitchenAid Induction Cooktop Code FC E4: the harness between touchpad and induction module FC LFKitchenAid Induction Cooktop Code FC LF: left front zone, its coil or its wiring FC LRKitchenAid Induction Cooktop Code FC LR: a left-side zone that will not heat FC RFKitchenAid Smoothtop Cooktop Code FC RF: right front area, element or wiring FC RRKitchenAid Induction Cooktop Code FC RR: the right rear zone does not respond H - Residual HeatKitchenAid Induction Cooktop H: Residual Heat Indicator Indicator or Display FlashingKitchenAid Induction Cooktop Flashing Display: Keys Held Down

F0E8F0E8 questions

What should I say when I call about F0E8?

Give us the exact code, the model and what you were doing when it appeared. Mention whether a reset cleared it for a while, since that helps us gauge how deep the problem goes.

Does F0E8 come from my pans?

Rarely. Unlike the cookware codes, this one asks for a power reset and service. Changing pans will not help if the display stays on F0E8.

Is it safe to leave the cooktop powered?

Leaving the breaker on is generally fine if nothing is heating, but we prefer it off while the code is active. Switch it off if you will not be home.