Booking today · Houston service windows 9–12 · 1–4 · 4–7 Independent KitchenAid specialists · Licensed & insured Mon–Fri 7:00 AM - 8:00 PM · Sat 8:00 AM - 6:00 PM
(713) 903-2606 Schedule Service
Model library · KitchenAid Cooktop

KECC501G

KitchenAid KECC501G 30-Inch Radiant Cooktop Repair

KitchenAid cooktop

Most common issues on this model

  1. A zone cutting out early because the limiter trips on glass heat
  2. One zone that never warms while others work
  3. An infinite switch stuck closed, giving full heat at every setting
  4. Cracked or chipped ceramic glass

The KECC501G is a 30-inch electric cooktop with radiant elements under ceramic glass. It was offered in the base number and as KECC501GAL, KECC501GBL3 and KECC501GWH, all sharing one layout. Because the elements sit directly beneath the glass, a thermal limiter monitors the temperature, and that limiter is what we suspect when a zone clicks off sooner than it should.

A zone that is completely dead while its neighbors run is a different path. We start at that zone’s switch, move to the terminal block, and finish by measuring the element itself, so only the failed piece is replaced. The opposite case, a zone locked at full heat, is nearly always a switch that stuck closed.

Cracks across the glass take the cooktop out of use until it is dealt with. We quote the repair in writing, and our work is covered for 30 days.

Key features

  • 30-inch ceramic-glass electric cooktop
  • Radiant elements
  • Variants: KECC501G, KECC501GAL, KECC501GBL3 and KECC501GWH
  • Discontinued model
→Codes

Error codes this model can show

KECC501GKECC501G questions
Why does a zone on my KECC501G turn off while I am boiling water?

The limiter under the glass is probably tripping because heat is not leaving the glass evenly. We test its operation and the element's contact with the glass before deciding which one to replace.

The KECC501G zone is glowing red on the highest setting even when I turn the knob down. Why?

The infinite switch has welded shut. Turn the breaker off to cool the zone. We confirm the cause with a meter and replace only the switch that failed.

Does the finish code on my KECC501G, such as AL or WH, matter for parts?

For electrical parts it does not, since the elements, switches and limiters are shared. We check the number on the rating plate to match the glass and trim correctly.

Book a visit

Book repair for your KECC501G

Book in about a minute, or call the desk. Same-day windows inside the Loop on most days, next-day across the rest of Houston.

☎ Call the desk ▤ Schedule Service