KitchenAid KSSS48FM Refrigerator Repair
The KSSS48FM is a discontinued side-by-side with an electronic control. When one of these starts misbehaving, the first thing we separate is sensing from power: is the cabinet cold or warm, and does the compressor actually start? A click every few minutes followed by silence points at the start relay and overload, while a cabinet that runs but never settles points at a drifting temperature sensor.
We measure the real air temperature in both sections, compare it with what the control reports, and then follow the compressor’s start sequence with a meter. If the cabinet is plumbed for water, the valve, tubing and filter housing get a look too, since a slow seep behind the cabinet can go unnoticed for weeks.
Because the KSSS48FM is no longer made, we confirm which control parts are still obtainable before we recommend a repair. The price is written down before we start, and the work is covered by our 30-day workmanship warranty.
It is typically the start relay or overload protector cycling because the compressor cannot start. We test both with a meter and check the compressor windings, so we replace only the part that failed instead of guessing.
Possibly the control board, but we check power to the board and the sensors before condemning it. A shorted sensor can mimic a bad board. If the board has failed, we confirm a replacement exists before quoting.
Look for dampness on the floor behind or beside the cabinet and a damp spot at the supply fitting. We check the valve, tubing and filter housing for seepage, and tighten or replace whatever is weeping.
Book in about a minute, or call the desk. Same-day windows inside the Loop on most days, next-day across the rest of Houston.
