KitchenAid Refrigerator Message "Water Filter Status Light Won't Reset": reset steps

What Water Filter Status Light Won't Reset means

On KitchenAid built-in refrigerators (KBSD, KBFN, KBBL, KBBR), French door bottom-freezer models (KRFC, KRMF, KRFF) and side-by-sides (KRSF, KRSC), such as the KBSD608ESS and KRFC704FPS, the water filter status does not reset by itself after a filter change. The method varies by model, for example holding FILTER RESET or holding WATER FILTER for 3 seconds. Owners keep seeing the replace reminder because the reset step was missed.

Common causes of Water Filter Status Light Won't Reset

The reset was not done after the filter change
The reset button was not held long enough
The filter is not yet changed and the reminder is correct

✓ One safe check you can try

1. Confirm a new water filter is installed, as filters are changed every 6 months or when the indicator lights. 2. Find the reset control for your model: FILTER RESET or WATER FILTER. 3. Press and hold it for 3 seconds. 4. Check that the indicator clears. 5. If it still will not reset, call us.

! Why to stop there

The light is a maintenance reminder, so no repair is involved
Holding the right button is an owner step
If the indicator will not clear on the right sequence, we can look at the control with a written price first

Opening a panel yourself does not automatically cancel a manufacturer warranty, but it can cause accidental damage, and some manufacturers set their own service conditions. Check your warranty terms, or ask us, before deciding.

→Same appliance

Other Refrigerator codes

Temperature AlarmKitchenAid Refrigerator Message "Temperature Alarm": cabinet above its limit Door Alarm LightKitchenAid Refrigerator Message "Door Alarm Light": door left ajar H2O LightKitchenAid Refrigerator Message "H2O Light": water filter status Over TempKitchenAid Wine Cellar Message "Over Temp": either zone above its range Over Temp Alarm (double drawer)KitchenAid Double-Drawer Refrigerator Message "Over Temp Alarm": drawers too warm Over Temperature Alarm (undercounter refrigerator / beverage center)KitchenAid Undercounter Refrigerator and Beverage Center Message "Over Temperature Alarm": 4 hours above limit Over Temperature LightKitchenAid Built-In Refrigerator Message "Over Temperature Light": cabinet too warm POKitchenAid Refrigerator Code PO: power outage indicator

Water Filter Status Light Won't ResetWater Filter Status Light Won't Reset questions

Why does the light stay on after I changed the filter?

The status does not reset automatically. You have to run the reset for your model, such as holding FILTER RESET or holding WATER FILTER for 3 seconds.

How often should the filter be replaced?

Every 6 months, or when the indicator lights. Replace it at that point and reset the status so the reminder starts counting again. Skipping the reset is the usual reason the light keeps asking.

Is a stuck reminder a failure?

No, this is a maintenance indicator and not a failure. If the right sequence does not clear it, call us and we will check the control.

KitchenAid Refrigerator Message “Water Filter Status Light Won’t Reset”: reset steps

What Water Filter Status Light Won't Reset means

Common causes of Water Filter Status Light Won't Reset

Other Refrigerator codes

Still unsure about Water Filter Status Light Won't Reset?