KitchenAid KCGD506G Cooktop Repair
Knobs on the KCGD506G take the most daily handling. After years of turning, the plastic socket or the shaft inside wears smooth, and the pointer stops lining up with the mark on the panel. You might turn to medium and get full heat. We check the knob, the shaft and the switch behind it, and replace whichever one is worn. Also sold as KCGD506GSS.
Two other calls come up often. A zone cutting out partway through cooking is usually a thermal limiter reacting to glass heat, and a zone that never warms is traced through its switch and wiring. On an induction version, we first try a plain magnetic pan, because non-magnetic cookware will never register.
A written price comes before work, and every repair carries a 30-day workmanship warranty.
Possibly, but it can also be a worn knob or shaft that turns without moving the switch fully. We compare the knob position against the switch with the power off, then test the switch under power.
A thermal limiter under the glass cuts power when the surface runs too hot. We test its trip point and the contact under the glass, which decides whether the limiter or the zone is the part to replace.
Check that a magnet sticks firmly to the pot bottom. If it does and the zone still ignores it, we test the coil and sensor connections. Aluminum and glass cookware will not work on an induction surface.
Book in about a minute, or call the desk. Same-day windows inside the Loop on most days, next-day across the rest of Houston.
