KitchenAid Combination Oven Code F4 E6: temperature sensing at the wave guide

What F4 E6 means

On KitchenAid combination microwave-wall ovens such as the KOCE507ESS, F4 E6 refers to the microwave wave guide temperature sensor, or the wiring connected to it. The code concerns the upper microwave cavity. The display shows it, and the microwave section may stay out of service until the sensor reading is trustworthy again. The oven is protecting a part of the microwave system it can no longer read, so avoid forcing repeated starts while the code is showing.

Common causes of F4 E6

Wave guide temperature sensor failing
Wiring or connector problem at that sensor

✓ One safe check you can try

1. Press Cancel and let the whole oven cool for at least thirty minutes. 2. Check that nothing blocks the oven vents. 3. Turn the breaker off for a minute and back on. 4. Try a short run with water. If F4 E6 shows again, call us.

! Why to stop there

The wave guide area is part of the microwave power path and carries high voltage.
Only measurements show which of the two, the sensor or the wiring, has the problem.
You see a written quote before work, and the repair is covered for 30 days.

Opening a panel yourself does not automatically cancel a manufacturer warranty, but it can cause accidental damage, and some manufacturers set their own service conditions. Check your warranty terms, or ask us, before deciding.

→Same appliance

Other Wall Oven codes

PUSH or PSHKitchenAid Wall Oven Message PUSH or PSH: Press start to begin Registration ErrorKitchenAid Wi-Fi Wall Oven Message Registration Error: Check internet connection Sabbath ModeKitchenAid Wall Oven Sabbath Mode: Bake-Only operation explained Sabbath, Sab, 5Ab, or 5A7KitchenAid Wall Oven Display Sabbath, Sab, 5Ab or 5A7: Cancelling the mode Temperature Reached Insert FoodKitchenAid Steam Oven Message Temperature Reached Insert Food: Preheat complete Locked, Lock or LocKitchenAid Wall Oven Message "Locked": the lock feature is on PF / PF id=27 / PF id=30KitchenAid Oven Display PF, PF id=27 and PF id=30: Power failure message Please Remove and Empty ContainerKitchenAid Steam Oven Prompt Please Remove and Empty Container: End of the drain cycle

F4 E6F4 E6 questions

What is a wave guide?

It is the channel that carries microwave energy into the cavity. Its temperature sensor watches that area, and F4 E6 means that sensor or its wiring may have a problem, so the oven cannot read it.

Should I let the oven cool first?

Yes. A cool-down of at least thirty minutes and one breaker reset are the only safe checks. A repeat code means the sensor or wiring needs testing, and we can do that on site.

Can I run the lower oven?

The lower oven is a separate cavity. Use it only if it runs without codes, and avoid starting the microwave while F4 E6 keeps returning, since the control cannot read that area.