Booking today · Houston service windows 9–12 · 1–4 · 4–7 Independent KitchenAid specialists · Licensed & insured Mon–Fri 7:00 AM - 8:00 PM · Sat 8:00 AM - 6:00 PM
(713) 903-2606 Schedule Service
Model library · KitchenAid Refrigerator

KBSN702M

KitchenAid KBSN702M Refrigerator Repair Help

KitchenAid refrigerator

Most common issues on this model

  1. A warm refrigerator side from an evaporator fan or duct problem
  2. Frost on the freezer evaporator from defrost trouble
  3. Door gasket wear on tall doors
  4. Water on the floor from a clogged drain or supply fitting

The KBSN702M is a 42-inch built-in with 25.5 cubic feet and a PrintShield finish that resists fingerprints, which also hides how often the doors are opened. Behind the finish, hinges and gaskets take that traffic, so we measure how squarely the doors close. Labels reading KBSN702MBS, KBSN702MPA or KBSN702MPS refer to the same cabinet.

The most common cooling complaint is a freezer that stays cold while the refrigerator side warms. That points to the shared evaporator, where frost or a tired fan can limit the air crossing over. We open the panel and check the coil, fan and defrost parts one at a time.

Because the unit is built in, we also clean the condenser area behind the grille. A written price is given before work, and every repair carries our 30-day workmanship warranty.

Key features

  • Side-by-side built-in, 42 inches wide
  • 25.5 cu. ft. capacity
  • PrintShield finish
  • Variants: KBSN702MBS, KBSN702MPA, KBSN702MPS
→Codes

Error codes this model can show

KBSN702MKBSN702M questions
My KBSN702M freezer is cold but the refrigerator is not. What do you inspect first?

We inspect the freezer evaporator for frost and test its fan, because one evaporator serves both sides. If the coil is clear and the fan runs, we check the air duct and the sensor.

Does the PrintShield finish on a KBSN702M need special care during repair?

We treat it like any fine finish: protect the door while working and avoid harsh cleaners. The finish does not change how the cooling system is tested or repaired.

What can cause water pooling under a KBSN702M?

A blocked defrost drain, a loose supply fitting, or a weeping valve. We dry the floor and test each connection, then flush the drain to see where the water comes from.

Book a visit

Book repair for your KBSN702M

Book in about a minute, or call the desk. Same-day windows inside the Loop on most days, next-day across the rest of Houston.

☎ Call the desk ▤ Schedule Service