KitchenAid KRFC302E Leak Defrost Repair
Water in the wrong place is the most frequent reason a KRFC302E, also sold as the KRFC302ESS, gets a service visit. The drain tube silts up with debris over the years, and meltwater escapes into the cabinet or onto the floor. We flush the tube, then watch it drain to be sure it stays clear.
If the cabinet is slowly warming, the evaporator is probably frosted over. A defrost heater, thermostat or timer has stopped doing its work, and the coil can no longer move air. We test them in turn rather than replacing all three.
An ice maker that fills but does not eject leaves a bin with a block of fused ice. We look at the module and the water path to find the cause. The sealed system is the last thing on our list, and if it has failed we say so plainly instead of patching around it. You see the price in writing first, and we back the repair with a 30-day workmanship warranty.
The drain tube is likely silted, so defrost meltwater has no route to the pan. We clear the tube, test the flow and check that the pan underneath is positioned and draining correctly.
We test the heater for continuity, the thermostat for its switching point and the timer for advancement, one at a time. Only the part that fails its test is replaced.
Usually not. It is more often an ice maker that fills but will not eject. We test the module and water path, and the cooling system stays out of the repair unless it tests badly.
Book in about a minute, or call the desk. Same-day windows inside the Loop on most days, next-day across the rest of Houston.
