Booking today · Houston service windows 9–12 · 1–4 · 4–7 Independent KitchenAid specialists · Licensed & insured Mon–Fri 7:00 AM - 8:00 PM · Sat 8:00 AM - 6:00 PM
(713) 903-2606 Schedule Service
Model library · KitchenAid Refrigerator

KSRI25FN

KitchenAid KSRI25FN Refrigerator Service Call

Schedule Service(713) 903-2606
KitchenAid refrigerator

Most common issues on this model

  1. Stiff gasket along one door edge that lets room air slip inside
  2. Control that misjudges the cabinet and runs the compressor for the wrong lengths of time
  3. Dripping inlet valve or feed line on cabinets with a water connection
  4. Burned-out start device that lets the compressor hum and then trip on overload

You might find a KSRI25FN, also sold as KSRI25FNBL, KSRI25FNSS and KSRI25FNST, anywhere from a family kitchen to a garage serving as a second fridge. Whichever room it sits in, the typical complaint is warm air creeping in along one edge of a door where the seal has stiffened.

A hard gasket never fully recovers, so the compressor runs longer, and the control may also read the cabinet wrongly and stretch the cycle further. If the compressor hums once and then drops out, the start device is a more likely suspect than the compressor.

We run a paper test around each door, check the control against a thermometer, and look at the water valve and tubing if the cabinet is plumbed in. The plate may show a revision code such as KSRI25FNBL00, which helps us match parts. Pricing is written before we begin, with a 30-day workmanship warranty.

Key features

  • Refrigerator
  • Out-of-production model
  • Finish versions: KSRI25FNBL, KSRI25FNSS, KSRI25FNST
  • Revision codes on rating plates: KSRI25FNBL00
→Codes

Error codes this model can show

Temperature AlarmKitchenAid Refrigerator Message "Temperature Alarm": cabinet above its limit Water Filter Status Light Won't ResetKitchenAid Refrigerator Message "Water Filter Status Light Won't Reset": reset steps Cooling Off Indicator LightKitchenAid Refrigerator Message "COOLING OFF": cooling switched off at the control DEMOKitchenAid Quad Door Message "DEMO": demonstration mode active Door AlarmKitchenAid Built-In Refrigerator Message "Door Alarm": door or drawer left open Door Alarm LightKitchenAid Refrigerator Message "Door Alarm Light": door left ajar H2O LightKitchenAid Refrigerator Message "H2O Light": water filter status Over TempKitchenAid Wine Cellar Message "Over Temp": either zone above its range
KSRI25FNKSRI25FN questions
One side of my KSRI25FN feels warm near the door edge. Is the seal bad?

That is a classic sign of a stiffened gasket. We test the seal with paper in several spots, warm and reshape it where possible, and replace the gasket if it no longer grips the cabinet.

The compressor in my KSRI25FN hums and shuts off. What is the likely cause?

A failed start device is common. We test it and the overload before looking at the compressor, since a new start device is a small repair compared with a compressor replacement.

My KSRI25FN runs nonstop. Is the control to blame?

Possibly. A control that misreads the cabinet keeps the compressor on too long. We compare its readings with a thermometer, check the door seals, and then confirm whether the board needs replacing.

Book a visit

Book repair for your KSRI25FN

Book in about a minute, or call the desk. Same-day windows inside the Loop on most days, next-day across the rest of Houston.

(713) 903-2606
☎ Call the desk ▤ Schedule Service