KitchenAid KSSC36MF Built-In Side-by-Side Repair
The KSSC36MF is a 36″ built-in side-by-side from the Superba series, and it is meant to disappear into your cabinetry. That placement shapes our visit: the unit sits flush with the joinery, so we plan how to reach the back and the machine compartment before touching anything, and we protect the surrounding panels.
At this age the door gaskets are the first place we look. A hardened gasket stops pulling the door tight, and warm air creeps in along one edge. Next comes temperature sensing; a sensor that has drifted gives a cabinet that cycles without ever settling. If yours is plumbed for water, we also trace the valve, the line and the filter housing for slow weeping behind the cabinet.
A click every few minutes with no cooling afterward points to the compressor start relay or overload. If your label says KSSC36MFS, that is the same model. We quote in writing first and stand behind the work for 30 days.
In most cases yes. The cooling parts, relay, fans and gaskets can be reached from the front and back access. We tell you before the visit if anything would require sliding the unit forward.
A repeating click usually means the start relay or overload is trying to start the compressor and giving up. We test both, measure the winding, and tell you plainly whether a relay replacement will fix it.
Only if your unit is plumbed for water. We then inspect the inlet valve, the supply line fittings and the filter housing for drips, and check the floor behind and below the cabinet for old moisture.
Book in about a minute, or call the desk. Same-day windows inside the Loop on most days, next-day across the rest of Houston.
